Electron Microscope Specimen Mounts and Holders
Electron Microscopy Sciences Mini SEM Clamp 10mm, 15mm dia.
Aluminum Mini SEM clamp on a 10 mm, 15 mm diameter M4 cylinder mount. Convenient for holding flat or thin specimens such as silicon chips, wires, foil and small tubes. Screw is M2 x 3 mm, pan head screw, brass.
Electron Microscopy Sciences Calibration Specimen 300-1D, Steel disk for AFM
SPM calibration specimens are produced by holographic fabrication that assures high accuracy and precision. The standards provide easier testing of your SPM, improved accuracy of critical dimension measurements and accuracy of 0.5% (1 std. dev.). The pattern height of greater than 100nm provides excellent image contrast. There is uniform coverage of entire chip which allows for imaging anywhere on the chip. Parallel Ridges. Pitch 288 W-coated Photoresist on Si Use contact or Tapping Mode.
Mount: AFM
Electron Microscopy Sciences Multi Pin Holder 45 degree for 3 pin stubs
This 25.4 mm in diameter 45 Degree multi pin holder is designed to save time. It allows for a higher SE signal without having to tilt the specimen It is made from machined aluminum with stainless steel Allen set screws. It accommodates up to three standard 12.7 mm (1/2") pin stubs with 3.2 mm (1/8") pin.
Electron Microscopy Sciences Standard Pin SEM Stub 9-Division 25 mm Head with 9 mm Pin, Aluminum, 3.2 mm Pin diameter
9 divisions surface min stub mounts are for use with FEI/Philips, ZEISS/LEO, Cambridge, Leica, Amray, Tescan and Camscan SEMs. Mounts are made from lathe finished ultra-pure aluminum.
Head: 1"
Pin height: 9 mm
Pin diameter: 3.2 mm
Electron Microscopy Sciences Standard Pin SEM Stub Slotted 18 mm Head with 8 mm Pin, Aluminum, 3.2 mm Pin diameter
Pin stub mount with slotted head for use with Cambridge, Leica, ZEISS/LEO, FEI/Philips, PHENOM, CamScan, and Tescan.
Head: 18 mm
Pin height: 8 mm
Electron Microscopy Sciences Standard Pin SEM Stub Mini, 6.6 x 1.3 mm Head, 9.5 mm Pin, Aluminum
Mini SEM pin stub mount for Cambridge, Leica, ZEISS/LEO, FEI/Philips, CamScan, Tescan, ETEC and Amray. Made from lathe finished ultra-pure aluminum.
Head: 6.6 x 1.3 mm
Pin height: 3/8"
